香港国際空港での荷物管理は RF ID でした [Other]
乗継便の遅延で帰国便が香港経由となってしまった為、久しぶりに香港国際空港にトランジットで寄りました。
そこで、荷物の乗り継ぎも行って貰ったのですが、家に帰ってきたらラゲッジに何か貼り付けてあります。
剥がしてみたら RF ID でした。
〔全景〕
アンテナの様子が良く分かります。
〔チップ部〕
ループアンテナにヒゲが付いているのでしょうか。
それとも折り畳みダイポールにマッチング・ユニットが付いているのでしょうか。
〔チップ部の拡大〕
チップにはアンテナだけが繋がっていると思ったら、なにやらタグが出ています。
これもアンテナの一部なんでしょうか。
よーく見ると面白いです。
そこで、荷物の乗り継ぎも行って貰ったのですが、家に帰ってきたらラゲッジに何か貼り付けてあります。
剥がしてみたら RF ID でした。
〔全景〕
アンテナの様子が良く分かります。
〔チップ部〕
ループアンテナにヒゲが付いているのでしょうか。
それとも折り畳みダイポールにマッチング・ユニットが付いているのでしょうか。
〔チップ部の拡大〕
チップにはアンテナだけが繋がっていると思ったら、なにやらタグが出ています。
これもアンテナの一部なんでしょうか。
よーく見ると面白いです。
KD1JV の新しい QRP リグ "slop bucket" [QRP]
KD1JV Steve OM が新しい QRP リグを構想しています。
今度は SSB リグです。
投稿された記事によれば
I just ordered proto boards for a SSB reversion of the Soda Pop, tentatively named "slop bucket".
It's based on the Survivor SSB rig design, but with a Si5351 VFO and of course, mostly SMT parts. It is slightly bigger then the soda pop board, but not by much.(92 x 100 mm). It includes a VOX circuit so it can be connected directly to a sound card for digital mode operation. I decided not to board mount the jacks this time for two reasons. 1) to keep the board smaller then 100 x 100 mm and 2) it allows more flexibility of enclosure choices.
だそうです。
ただ、限定50台なのでとてもゲットできそうにありません。
今度は SSB リグです。
投稿された記事によれば
I just ordered proto boards for a SSB reversion of the Soda Pop, tentatively named "slop bucket".
It's based on the Survivor SSB rig design, but with a Si5351 VFO and of course, mostly SMT parts. It is slightly bigger then the soda pop board, but not by much.(92 x 100 mm). It includes a VOX circuit so it can be connected directly to a sound card for digital mode operation. I decided not to board mount the jacks this time for two reasons. 1) to keep the board smaller then 100 x 100 mm and 2) it allows more flexibility of enclosure choices.
だそうです。
ただ、限定50台なのでとてもゲットできそうにありません。
QST 11月号に QRPguys から基板を買って作っている Antenna Analyzer の記事が載りました [Arduino]
ARRL から ARRL Handbook 2018 の案内が来ました [Operation]
ARRL から ARRL Handbook 2018 の案内が来ました。
目新しいところは
New Projects として
・VHF/UHF/Microwave Filters and Transmission Lines
・Software-Controlled and Manual Preselectors for 1.8-30 MHz
・Digital Mode Audio-Based VOX/PTT Interface
・PICAXE-Based Timer
・Arduino-Based CW IDer
・6-Meter Halo Antenna
・Big Wheel VHF/UHF Mobile Antenna
・Off-Center End-Fed Portable 40-6 Meter Antenna
・Crossed-Dipole Omnidirectional Antenna for 1296 MHz
・Spudgun Antenna Launcher
・CW Reception Filter
と書かれており、さらに
Plus, new and updated content on Software Defined Radio (SDR) and Digital Signal Processing (DSP), Grounding and Bonding, Solar Cycle 24-25, Tower Safety, and Building Remote-Control Stations.
も追加、アップデートされています。
う~ん、注文しようかなぁ....
目新しいところは
New Projects として
・VHF/UHF/Microwave Filters and Transmission Lines
・Software-Controlled and Manual Preselectors for 1.8-30 MHz
・Digital Mode Audio-Based VOX/PTT Interface
・PICAXE-Based Timer
・Arduino-Based CW IDer
・6-Meter Halo Antenna
・Big Wheel VHF/UHF Mobile Antenna
・Off-Center End-Fed Portable 40-6 Meter Antenna
・Crossed-Dipole Omnidirectional Antenna for 1296 MHz
・Spudgun Antenna Launcher
・CW Reception Filter
と書かれており、さらに
Plus, new and updated content on Software Defined Radio (SDR) and Digital Signal Processing (DSP), Grounding and Bonding, Solar Cycle 24-25, Tower Safety, and Building Remote-Control Stations.
も追加、アップデートされています。
う~ん、注文しようかなぁ....